Roof Coat-6 Ply Canvas System Waterproofing
General product information
6 PLY Canvas System( Masonry / Cementitious Surface )
Introduction:
RG-2090-Roof Coat is a specially blended One Component, Cold Applied and Ready To Use polymer based air drying sealing-insulating and waterproofing compound based on SAR and other essential resins.
Surface preparation :
When applying make sure that the surface to be applied is dry, free from dust, dirt, oil, and grease. Press fill uniformly to the deep without leaving any air pocket or cavities to obtain best results.
Uses:
The application of RG-2090 Roof Coat are many and varied. It is ideal for waterproofing of roofs, basements, OH/UG tanks, pools, ponds, foundations, Construction-Expansion joints, Asbestos sheet gaps, RCC pipe joints, Pre cast slab gaps etc.
Application Procedure;
·Applying 1st coat of mixture of RG-Uni Bond Adhesive and Roof Coat ( 60;40 ), as primer coat diluted with normal soft water between 10 to 20% depending upon the atmospheric conditions and temperature of the surface applied on.
·Thorough checking of the primed surface of voids, holes, cracks & gaps and repairing/filling the same using RG-2030-Flexi Bond.
·Applying 2nd coat of RG-2090 Roof Coat.
·Applying 3rd coat of RG-Uni Bond Adhesive and subsequently firmly pasting 8-10 Oz. Canvas Cloth ( 4th coat/Ply ) while the same is wet with 2 inches overlap on all joints/laps including 4' drop on all edges. In case of roof having parapet walls/rises at least 6' vertical pasting to be carried out.
·Applying 5th coat of RG-Roof Coat over the Canvas cloth surface suitably diluted. It is advisable to apply flood coat diluting upto 30% with normal soft water.
·Securing edges of all lap joints and edges by RG-2030 Flexi Bond.
·Applying 6th coat as final coat of RG-Roof Coat.
Technical Data
Colours Available : White, Gray, Other colours as ordered on bulk.
Consistency : Moderately viscous liquid.
Flash Point : None-water based.
Specific Gravity : 1.45 +/- 0.025 at 20° C
Tensile Strength : 295 kgf/cm² ( ASTM D - 412 )
Peel Adhesion : 60 lb/inch²
Solid : 57 +/- 1% ( ASTM D-1644 )
Shore Hardness : Between 5° C to 80° C.
Storage Stability : Eight to Ten Months when stored properly in
Original sealed containers in a dry place.
Packing : 20 Kg, 40 kg, 5 Kg.